MX16 Gas Detection Control Panel
The MX16 Controller is designed for monitoring a single gas detector in MRI room, laboratory, storage, small boiler room, and breweries or battery charging rooms. The MX16 measuring unit prevents the risks of gas building up in areas that could be anoxic, toxic or explosive gases in ambient air. Units..
MX16-N-002-0-0-0
Easy Duo MX16 Gas Detection Controller with OLCT10N for CH4 (Methane) fitted with 10m cable. Range 0-4.4% Volume. 2 Alarm levels (Al1 and Al2) + 1 fault, with Dry Contact Relays. LCD back-lit display. IP55 Enclosure with 3 x M16 and 2 x M20 cable glands. Dimensions 265 x 266..
N322S Electronic Thermostat For Solar Heating
The N322S Electronic Thermostat is designed solar water heating control. The main relay used to control the water circulation from the roof to storage tank. The display has the same options as the N322 but includes a differential controller that compares two different sensors, ensure water is only cycled from..
N480D Series PID Temperature Controller
The N480D series of PID temperature controllers were designed to provide a high performance inexpensive high end controller with simple configuration and use. The controller will accept temperature inputs from Thermocouples and PT100 RTD sensors and has a wide range of options for SPST, SPDT, logic pulse and 4-20mA outputs...
OLCT10 Gas Detectors for Refrigerant and Toxic Gases
The OLCT10 TOX gas detectors are designed for commercial applications for the detection of refrigerant gases and the presence of exhaust gases from combustion in ambient air. These detectors are ideal for the continuous monitoring of toxic gases in car parks, boiler rooms and plant rooms for shops and warehouses...
OLCT10N-AP-002
OLCT10N-AP-002 Poison Resistant Gas Detector for Methane (CH4), Range 0-4.4% Volume. Output: RS485 Modbus RTU. Power Supply: 12-30vDC, Consumption 50mA typ. Operating temperature: -20 to +55°C. Life span: 48 Months. Plastic housing, 118 x 157 x 60mm, IP65. Non-Hazardous Area Only...
Omni-F Flow Transmitter/Switch
The Omni-F Flow Transmitter/Switch is a calorimetric flow sensor designed for measuring flow rates in aqueous fluids. It provides a 4(0)-20mA or 0(2)-10V output, along with a digital display for local indication of flow measurement. The device incorporates two programmable push-pull switches and features a microcontroller for temperature compensation, signal..
OMNI-F-008HK028IS
OMNI-F Series Flow Transmitter/Switch. Supply Voltage: 24vDC ±10% @ <1 W. Switching Output, I (max)= 100mA. Backlit Graphical LCD Display 008 - ¼" BSP Thread Connection H - Male Thread K - Stainless Steel 1.4571 Connection Material 028 -Sensor Length 28mm I - 0/4-20mA Current Output S - M12 x..
OMNI-F-015HK029ISO-67
OMNI-F Series Flow Transmitter/Switch. Supply Voltage: 24vDC ±10% @ <1 W. Switching Output, I (max)= 100mA. Backlit Graphical LCD Display 015 - ½" BSP Thread Connection H - Male Thread K - Stainless Steel 1.4571 Connection Material 029 -Sensor Length 29.6mm I - 0/4-20mA Current Output S - M12 x..
Omni-HR2VE Flow Transmitter/Switch
The Omni-HR2VE Flow Transmitter/Switch is a Flow sensor optimised for measuring flow rate of oil using a spring-supported piston with hall effect sensor. It provides a 4(0)-20mA or 0(2)-10V output, along with a digital display for local indication of flow measurement. The Omni-HR2VE features a programming ring that can be..
Omni-VHS Flow Transmitter/Switch Screw Volumeter
The Omni-VHS Flow Transmitter/Switch is a Volumetric flow sensor designed for measuring flow rates in viscous, lubricant media. It provides a 4(0)-20mA or 0(2)-10V output, along with a digital display for local indication of flow measurement. The Omni-VHS features a programming ring that can be turned to different positions to..
PA-DPS-91W
PA-DPS Differential Air Pressure Switch in an IP65 enclosure. Range 50-500 pascals with a Silver Cadmium Oxide (AgCdO) contacts suitable for up to 5A (0.8A)/230vAC or 2A @ 30vDC. 6mm id pressure connections. Dimensions 81mm diameter x 52mm high. Units come complete with duct fixing kit (consisting of 2 x..
PR41XEi Intrinsically Safe Low Range Pressure Transmitter.
The PR41XEi series are designed for measuring very low pressure values in the mBar or µBar ranges in hazardous areas. The Series 41XEi capacitive pressure transmitter from Keller combines a ceramic measurement cell for low pressure ranges with the µP electronics of the digital series 30 transmitter. The pressure values..
RHT Relative Humidity and Temperature Transmitters
RHT-DM & RHT-DM Relative Humidity and Temperature Transmitters RHT-WM and RHT-DM with dual 4-20mA outputs for temperature and humidity or dew point. RHT-WM is Wall Mounted unit with integrated sensor below the enclosure. The RHT=DM is a Duct Mounted version with the probe behind the enclosure. Options available for a..
RME2 Ethernet Web Enabled Analogue Acquisition Unit
The RME2 is an analogue acquisition module that will accept 4-20mA, 0-10V, PT100 and thermocouple (Type J, K, T, R, N, E, S) inputs. The unit provides an output over Modbus TCP, web page (HTTP), SNMP (Version 1), CVS and XML. Data can be viewed in real time, table and..
RMS1-OX-110160-0X-GR-MB
Remote Inputs Module, 16 Opto isolated digital inputs. RS232/RS485 Modbus ASCII/RTU Communication, Wide power supply range: 10 up to 30vDC, DIN rail mounting...
RTD-SURFACE-CURVED-2MFL
Self-Adhesive Surface Mounted PT100 Class A Sensor with 2m PFA Insulated Cable. Measurement Range -30 to +150°C. Suitable for a curved surface mounting with a 16 x 50mm rubber patch..
Senturion XPD25 Disc Mounted Proximity Probe
The Senturion XPD25 Proximity probe system with a disc mount proximity sensor with a 55.0mm diameter. The probe uses eddy current principle to measure distance up to 25.0mm with resolution of less than 0.003mm. It is designed for monitoring targets from as little as 50mm, even in a harsh environments..
SGR Series Rotary Transducer For Torque, Speed & Power Measurements – External Electronics
These SGR Series Transducers can be used to monitoring bi-directional rotary or static torque with an external electronics box. An integrated speed sensor enable the direct measurements of transmitted power and RPM. The SGR Series Transducers operate using a four-element strain gauge wheatstone bridge, which connects to a microcontroller to..
SGR522
SGR522 TorqSense Torque sensor with variable analogue outputs for Torque, Speed and Power measurements with integral electronics. Torque ranges from 0-175mNm to 0-13,000 Nm and 360 Pulse/Revolution...
SharpEye Premium 40/40D Flame Detector.
The SharpEye next generation premium 40/40D series features ultra fast detection (less than 50msec) of hydrocarbon-based fuel and gas fires at the longest distance at up to 300 ft (90 m) using pioneering QuadSense technology. This series is suited to meet the challenges of any high-risk industrial application with revolutionary..
Simex SRT-N118 LED Display
The SRT-N118 temperature meter features easy operation, functional programming menu and a clear 4 digit, 20mm LED display. The display is housed in a wall mounted, IP67 case making it an ideal choice for heavy-duty applications. The unit will measure inputs, PT100, PT500, PT1000 and Thermocouples (type K, J, S,..
SMP3 Smart Pyranometer
The SMP3 Pyranometer is a spectrally flat class C pyranometer with an amplified analogue and RS485 Modbus RTU output. The SMP3 is identical to the CMP3 pyranometer but includes a Modbus interface allowing for an improved response time and rescaleable, temperature corrected measurement data. The amplified output options are 0-1V..
