Tinytag CAB-3249 Voltage/Current Input Lead for connection of voltage and current input signals to Tinytag data loggers. Includes a 5-pin connection to logger and 1m flying tails. ...
Tinytag CAB-3246 Count Input Lead for connection of 2-wire input signals to Tinytag data loggers. Includes a 2-pin connection to logger and 1m flying tails. ...
General Purpose K-Type Penetration Probe, 100mm x 3.3mm diameter. Supplied with 1 metre PTFE Insulated Lead and a K Therm MiniPlug connector. Probe Temperature Range: -75 to +250°C, Response Time: <5 Seconds ...
5331A3B programmable transmitter with a 7.2-35vDC power supply. Single channel unit for PT100, thermocouple, Resistance or bi-polar mV input, producing a 2-wire 4-20mA output. 1.5kvAC galvanic isolation. Programmed to suit the connected sensor. Transmitter fitted in weatherproof enclosure with 2 cable glands. ...
Calibration Certificate for OQ610 Data Logger. OQ610 logger inputs calibrated at 5 points on the T and K type input ranges at 2%, 25%, 50%, 75% and 98% of each range. ...
SCS Calibration Certificate for MiniAir anemometers, vane anemometers fitted to MiniAir display units and cup anemometers. Price covers a 5 point calibration. ...
Calibration 2 Axis - Fixed Point (Wind Tunnel). The calibration procedure involves the unit being fixed in one point facing North with a varying wind speed from 0 to 30 or 40m/s. The calibration certificate then compares the wind tunnel velocity readings to those collected by the unit. ...
Initial Calibration Certificate for Infrared Sensors, PyroMini, PyroCouple and PyroPen. UKAS traceable certificate showing the measured temperature at three points across the sensors temperature range. Only available when ordered along with a brand new sensor. ...
Licence Key to allow a CMC-99 unit to log data. 1.5GB of internal memory, up to 250 million samples, and a maximum logging speed of 10Hz (limited to a number of recording channels). ...
Quick-fit to stainless steel flat base adapter for attachment with epoxy resin. Provides a high rigidity connection but with reduced high frequency response. ...
Initial Calibration of pressure sensors purchased from Omni Instruments. Pressure Calibration to 5 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for ...
Non-melting hydrocarbon grease. Low contact resistance. 50ml tube. Provides a clear contact from sensor to the surface to improve the ultrasonic signal. ...
2.4GHz Wi-Fi body mounted antenna. Dome shaped, robust waterproof housing. ...
CAB-3239
Tinytag CAB-3249 Voltage/Current Input Lead for connection of voltage and current input signals to Tinytag data loggers. Includes a 5-pin connection to logger and 1m flying tails. ...
CAB-3246
Tinytag CAB-3246 Count Input Lead for connection of 2-wire input signals to Tinytag data loggers. Includes a 2-pin connection to logger and 1m flying tails. ...
1122449
Straight 4-pin M12 female mating connector. Connection secures with an M12 screw locking system. IP67 Protection rating. ...
113-158
General Purpose K-Type Penetration Probe, 100mm x 3.3mm diameter. Supplied with 1 metre PTFE Insulated Lead and a K Therm MiniPlug connector. Probe Temperature Range: -75 to +250°C, Response Time: <5 Seconds ...
5331A3B-ENCL
5331A3B programmable transmitter with a 7.2-35vDC power supply. Single channel unit for PT100, thermocouple, Resistance or bi-polar mV input, producing a 2-wire 4-20mA output. 1.5kvAC galvanic isolation. Programmed to suit the connected sensor. Transmitter fitted in weatherproof enclosure with 2 cable glands. ...
551-71
30ml Fill Solution for Polargraphic dissolved Oxygen probe. ...
6312288
MX48 and MX52 COM 48/52 software for easy configuration. ...
890-111
UKAS 3 point Calibration certificate. Only available if purchased at the same time as the meter. ...
SAFT LS26500 Size C Battery. Capacity 3.6V @ 7.7Ah. ...
CAL-610
Calibration Certificate for OQ610 Data Logger. OQ610 logger inputs calibrated at 5 points on the T and K type input ranges at 2%, 25%, 50%, 75% and 98% of each range. ...
CAL-SCS-ANEMOMETER
SCS Calibration Certificate for MiniAir anemometers, vane anemometers fitted to MiniAir display units and cup anemometers. Price covers a 5 point calibration. ...
CAL2AXISFIXEDPOINT
Calibration 2 Axis - Fixed Point (Wind Tunnel). The calibration procedure involves the unit being fixed in one point facing North with a varying wind speed from 0 to 30 or 40m/s. The calibration certificate then compares the wind tunnel velocity readings to those collected by the unit. ...
CALCERT A
Initial Calibration Certificate for Infrared Sensors, PyroMini, PyroCouple and PyroPen. UKAS traceable certificate showing the measured temperature at three points across the sensors temperature range. Only available when ordered along with a brand new sensor. ...
CMC-99-LOGGER
Licence Key to allow a CMC-99 unit to log data. 1.5GB of internal memory, up to 250 million samples, and a maximum logging speed of 10Hz (limited to a number of recording channels). ...
GC-60
Transmitters for use with external probes - Wired sockets for 2 x state indications (e.g. door open/close) ...
KTC-EXT-CAB-100M-REEL
Type K extension cable 7/0.2mm PVC flat pair. c100M length Reel ...
MTN/MS001
Quick-fit to stainless steel flat base adapter for attachment with epoxy resin. Provides a high rigidity connection but with reduced high frequency response. ...
NPL-CAL-5 POINTS
Initial Calibration of pressure sensors purchased from Omni Instruments. Pressure Calibration to 5 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for complete traceablility. ...
PA-TUBE-8MM
PVC tube 8mm outside diameter x 1.5mm wall, 30m reel. Suitable for connecting the PA267 to AV-EP & AV-MPS probes. ...
UA-USB-232-ISO
USB to RS232 adapter, optically isolated, Panel or DIN Rail mountable. Supplied with 3 foot USB cable. ...
ULTRA-COP
Non-melting hydrocarbon grease. Low contact resistance. 50ml tube. Provides a clear contact from sensor to the surface to improve the ultrasonic signal. ...
WCDCOM32
COM 32 Installation CD with USB cable ...
WIFIBM
2.4GHz Wi-Fi body mounted antenna. Dome shaped, robust waterproof housing. ...
Tinytag CAB-3249 Voltage/Current Input Lead for connection of voltage and current input signals to Tinytag data loggers. Includes a 5-pin connection to logger and 1m flying tails. ...
Tinytag CAB-3246 Count Input Lead for connection of 2-wire input signals to Tinytag data loggers. Includes a 2-pin connection to logger and 1m flying tails. ...
General Purpose K-Type Penetration Probe, 100mm x 3.3mm diameter. Supplied with 1 metre PTFE Insulated Lead and a K Therm MiniPlug connector. Probe Temperature Range: -75 to +250°C, Response Time: <5 Seconds ...
5331A3B programmable transmitter with a 7.2-35vDC power supply. Single channel unit for PT100, thermocouple, Resistance or bi-polar mV input, producing a 2-wire 4-20mA output. 1.5kvAC galvanic isolation. Programmed to suit the connected sensor. Transmitter fitted in weatherproof enclosure with 2 cable glands. ...
Calibration Certificate for OQ610 Data Logger. OQ610 logger inputs calibrated at 5 points on the T and K type input ranges at 2%, 25%, 50%, 75% and 98% of each range. ...
SCS Calibration Certificate for MiniAir anemometers, vane anemometers fitted to MiniAir display units and cup anemometers. Price covers a 5 point calibration. ...
Calibration 2 Axis - Fixed Point (Wind Tunnel). The calibration procedure involves the unit being fixed in one point facing North with a varying wind speed from 0 to 30 or 40m/s. The calibration certificate then compares the wind tunnel velocity readings to those collected by the unit. ...
Initial Calibration Certificate for Infrared Sensors, PyroMini, PyroCouple and PyroPen. UKAS traceable certificate showing the measured temperature at three points across the sensors temperature range. Only available when ordered along with a brand new sensor. ...
Licence Key to allow a CMC-99 unit to log data. 1.5GB of internal memory, up to 250 million samples, and a maximum logging speed of 10Hz (limited to a number of recording channels). ...
Quick-fit to stainless steel flat base adapter for attachment with epoxy resin. Provides a high rigidity connection but with reduced high frequency response. ...
Initial Calibration of pressure sensors purchased from Omni Instruments. Pressure Calibration to 5 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for ...
Non-melting hydrocarbon grease. Low contact resistance. 50ml tube. Provides a clear contact from sensor to the surface to improve the ultrasonic signal. ...
Need help with your products or have a question for us on our custom systems? Use the form below to send us a message and our experts will be in touch to help.
