CAL-SCS-THERMOAIR
SCS Calibration Certificate for ThermoAir anemometers and Thermoelectric anemometers fitted to ThermoAir display units. Price covers a 5 point calibration..
CAL2AXISROTATE
Calibration 2 Axis - Rotate (Wind Tunnel). The calibration procedure involves a fixed wind velocity and the unit is rotated from 0 to 360 Degrees in 180 separate steps, providing a reading every 2 Degrees. The calibration certificate then compares the fixed wind velocity of the wind tunnel to the..
CALCERT B
Recalibration Certificate for Infrared Sensors, PyroMini, PyroCouple and PyroPen. UKAS traceable certificate showing the measured temperature at three points across the sensors temperature range...
CALPROB
2 Point calibration of oven temperature probe...
CMC-99-EMAIL
CMC-99 E-mail Notifications Licence Key. CMC-99 will automatically send Email notification messages via Ethernet connection. E-mail notifications can be used as devices state report when an alarm or a specified signal occurs...
E2-02XX
2m Anthracite extension cable for HC2 Probe with flying leads..
GC-62
GEN II radio transmitter for use with pulse outputs from flow, gas, energy or heat meters and any other devices with a pulse output. The transmitter will accept up to 2 pulse inputs, max 250Hz and 65,000 pulses per logging period, counter resets for each transmission. Operating Range -30 to..
MTN/MS013
¼" - 28 UNF male to stainless steel flat base adapter for attachment with epoxy resin. Provides a rigid connection that maximises the response at high frequencies...
NPL-CAL-11 POINTS
Initial Calibration of pressure sensors purchased from Omni Instruments. Pressure Calibration to 11 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for..
CAL-SCS-THERMOAIR-ADD
SCS Calibration Certificate for ThermoAir anemometers and Thermoelectric anemometers fitted to ThermoAir display units. Price covers additional probes over a single flow range or additionals ranges on the same probe...
CMC-141-EMAIL
CMC-141 E-mail Notifications Licence Key. CMC-141 will automatically send Email notification messages via Ethernet connection. E-mail notifications can be used as devices state report when an alarm or a specified signal occurs...
E2-05XX
5m Anthracite extension cable for HC2 Probe with flying leads..
MTN/MS067
¼" - 28 UNF male to M8 male stainless steel stud adapter. Provides a rigid connection that maximises the response at high frequencies...
CMC-N16-EMAIL
CMC-N16 E-mail Notifications Licence Key. CMC-N16 will automatically send Email notification messages via Ethernet connection. E-mail notifications can be used as devices state report when an alarm or a specified signal occurs...
MTN/MS124
¼" - 28 UNF male to M10 male stainless steel stud adapter. Provides a rigid connection that maximises the response at high frequencies...
133-222
General Purpose K-Type Penetration Probe, 100mm x 3.3mm diameter. Supplied with 5 metre PTFE Insulated Lead and a K Therm MiniPlug connector. Probe Temperature Range: -75 to +250°C, Response Time: <5 Seconds. Part Ref 133-222..
NPL-RECAL-5 POINTS
UKAS traceable calibration of customers own pressure sensors. Pressure Calibration to 5 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for complete..
NPL-RECAL-11 POINTS
UKAS traceable calibration of customers own pressure sensors. Pressure Calibration to 11 points. All ranges between -0.8 and 1,000 Bar. Certificate shows actual output readings in graph and table form. Maximum errors shown at each point as a percentage. Certificate is timed, dated and has a unique reference for complete..
97RA
6 digit LED display, AC frequency input for flow rate, suitable for displaying flow rate from turbine meters with AC output. Frequncy range 1-10,000 Hz, accuracy 0.05% of reading, power supply 8-13v DC, operating temperature 0-50 deg C, dimensions 96 x 48 x 104mm deep...
CAL3AXISROTATE
Calibration 3 Axis - Rotate (Wind Tunnel). The calibration procedure involves a fixed wind velocity and the unit is rotated from 0 to 360 Degrees in 180 separate steps, providing a reading every 2 Degrees. The calibration certificate then compares the fixed wind velocity of the wind tunnel to the..
E3-01A
1m White extension cable for HC2 Probe with connector...
GS-61
Transmitters for use with external probes - Wired sockets for 8 x state indications (e.g. door open/close)..
LEO2-CALIBRATION-UKAS
Calibration of Leo 1 & Leo 2 manometers calibrated in accordance with ISO/IEC 17025:2005 by UKAS accredited calibration laboratories..
E3-05A
5m White extension cable for HC2 Probe with connector...
