CAB-3239
Tinytag CAB-3249 Voltage/Current Input Lead for connection of voltage and current input signals to Tinytag data loggers. Includes a 5-pin connection to logger and 1m flying tails...
CAB-3246
Tinytag CAB-3246 Count Input Lead for connection of 2-wire input signals to Tinytag data loggers. Includes a 2-pin connection to logger and 1m flying tails...
133-158
General Purpose K-Type Penetration Probe, 100mm x 3.3mm diameter. Supplied with 1 metre PTFE Insulated Lead and a K Therm MiniPlug connector. Probe Temperature Range: -75 to +250°C, Response Time: <5 Seconds. Part Ref 133-158..
5331A3B-ENCL
5331A3B programmable transmitter with a 7.2-35vDC power supply. Single channel unit for PT100, thermocouple, Resistance or bi-polar mV input, producing a 2-wire 4-20mA output. 1.5kvAC galvanic isolation. Programmed to suit the connected sensor. Transmitter fitted in weatherproof enclosure with 2 cable glands...
551-71
30ml Fill Solution for Polargraphic dissolved Oxygen probe...
825-990
This manometer hose set will fit the 9215, 9230 & 9275 series handheld pressure meters. Supplied as 2 x 300 mm lengths x 4mm ID it allows accurate gas pressure testing of heating appliances, flue draught measurement etc...
825-998
This manometer hose set will fit the 9205 series handheld pressure meters. Supplied as 2 x 500 mm lengths x 6mm ID it allows accurate gas pressure testing of heating appliances, flue draught measurement etc...
890-111
UKAS 3 point Calibration certificate. Only available if purchased at the same time as the meter...
BATT-SB-1/2AA
SAFT LS14250 Size ½AA Battery. Capacity 3.6V @ 1.2Ah...
BATT-SB-C
SAFT LS26500 Size C Battery. Capacity 3.6V @ 7.7Ah...
CAL-SCS-ANEMOMETER
SCS Calibration Certificate for MiniAir anemometers, vane anemometers fitted to MiniAir display units and cup anemometers. Price covers a 5 point calibration...
CAL2AXISFIXEDPOINT
Calibration 2 Axis - Fixed Point (Wind Tunnel). The calibration procedure involves the unit being fixed in one point facing North with a varying wind speed from 0 to 30 or 40m/s. The calibration certificate then compares the wind tunnel velocity readings to those collected by the unit...
CALCERT A
Initial Calibration Certificate for Infrared Sensors, PyroMini, PyroCouple and PyroPen. UKAS traceable certificate showing the measured temperature at three points across the sensors temperature range. Only available when ordered along with a brand new sensor...
CMC-99-LOGGER
Licence Key to allow a CMC-99 unit to log data. 1.5GB of internal memory, up to 250 million samples, and a maximum logging speed of 10Hz (limited to a number of recording channels)...
GC-60
Transmitters for use with external probes - Wired sockets for 2 x state indications (e.g. door open/close)..
KTC-EXT-CAB-100M-REEL
Type K extension cable 7/0.2mm PVC flat pair. c100M length Reel..
MTN/MS001
Quick-fit to stainless steel flat base adapter for attachment with epoxy resin. Provides a high rigidity connection but with reduced high frequency response...
ULTRA-COP
Non-melting hydrocarbon grease. Low contact resistance. 50ml tube. Provides a clear contact from sensor to the surface to improve the ultrasonic signal...
551-72
30ml Fill Solution for Galvanic Dissolved Oxygen Electrode...
CAL-SCS-ANEMOMETER-ADD
SCS Calibration Certificate for MiniAir anemometers, vane anemometers fitted to MiniAir display units and cup anemometers. Price covers additional probes over a single flow range or additionals ranges on the same probe...
CMC-141-LOGGER
Licence Key to allow a CMC-141 unit to log data. 1.5GB of internal memory, up to 250 million samples, and a maximum logging speed of 10Hz (limited to a number of recording channels)...
GC-60F
GEN II radio transmitter with wired sockets for connection to water detection cables. The GC-60F will transmit a 1.0 value for OK and a 0.0 value to indicate the presence of water on the active portion of the detection cable. Supplied with 4 x AA Alkaline batteries, stub antenna and..
MPU18V
100-240VAC 50/60Hz Mains Adapter supplied with 4-single fit mains plugs for UK, Euro, US and AUS/NZ. Powers SQHUB and Data Loggers. Output 18VDC, 1.6A..
MTN/MS002
Quick-fit to M8 male stainless steel stud adapter. Provides a high rigidity connection but with reduced high frequency response...
