Downloads

Datasheet

Ultrasonic Flow Meter - OMNI-ECO-200M

Description

OMNI-TUF-200M DIN-Mount Ultrasonic Flow meter supplied with transducers for pipe sizes 25-100mm, 50-700mm or 300-6,000mm, complete with manual and stainless steel straps. 

Features:

  • High accuracy. Normally, ±1%. When on-site calibration available, ±0.5%.
  • Wide flow range 0.03 to 105ft/s.
  • Wide pipe size range (from 1″ to 240″).
  • Noninvasive. No pipe disturbance. No moving parts, no pressure drop.
  • Easy and economical installation. No cutting pipe, non drilling hole.
  • Suitable for all commonly used pipe materials
  • Easy to use and set up. Self-explanatory menu programming
  • Velocity, volumetric and total flow
  • GPRS / GSM networking capability with certain model
  • Ideal for both clean and opaque liquid flow measurements

 

  Specification
 Repeatability  0.2%
 Accuracy  Normally better than ±1%. Could be ±0.5% with on-site calibration.
 Response Time  0.5 Seconds
 Units  Imperial or metric
Signal Outputs  Current output:1 x 4-20mA flow rate
 OCT output: 2 x flow totals and/or alarms
 1x MODBUS RS485
 Data Logger  Automatically record the following information:
1) The totalizer data
2) The power time and corresponding flow rate
3) Allow manual or automatic flow loss compensation
4) The instrument working status32,00 reading capacity
 Computer Interface  RS485
 Liquids  Type: Virtually all commonly used liquids (full pipe)
 Temperature: 32Ó?F – 212Ó?F (0Ó?C – 100Ó?C)
 Concentration: <10,000ppm and small air bubble concentration
 Pipe  Sizes: 1″ – 240″
 Materials: All metals, most plastics, fiber glass, etc.
 Pipe Length: Better longer than 15D, where D is pipe diameter. If a pump is near,  the straight pipe section following the pumps should be > 30D
 Cable Shielded transducer cable. Standard length 15ft (5m), longer cables are available  up to 25m. Cable should not be laid in parallel with high-voltage power lines,  neither should it be close to strong interference source such as power  transformers.
 Power  9 to 36vDC or 10vAC to 36vAC

 

Transducer Specifications
Type S1 Small size transducer (magnetic)
For pipe size 1” – 4”
Type M1 Standard medium size transducer (magnetic)
For pipe size 2” – 28”
Type L1 Large size transducer (magnetic)
For pipe size 11” – 240”