Description

Tape Mounting Procedure

1. Ensure the wall mounting site is clean and dry by cleaning and removing all grease and dust residues.
2. Mount the sensor on the exposed side of the tape. Ensure the sensor cable is perpendicular to the direction of unfurling the tape roll as shown in Figure 1(a). This is to create a removal tab towards the side of the sensor.
3. Cut an additional 2cm length of tape extending beyond the edge of the sensor as in Figure 1(b)
4. Fold back the additional length of tape onto itself to create a removal tab as in Figure 1(c)
5. Peel off the yellow protective film as in Figure 1(d) and mount the sensor onto desired surface. Firmly and evenly apply pressure on the sensor using your fingers for 4-5 seconds to ensure good adhesion. Do not apply uneven pressure on the sensor using any hard objects.