High Precision Transmitters Series 36 X W for Level Measurements
Digitally compensated / Rangeable / Digital and Analog Output
These pressure transmitters are designed for level measurements where the highest accuracy is required.
Digital Output of Transmitter
This Series is based on the stable, piezoresisitive transducer and a micro-processor electronics with integrated 16 bit A/D converter. Temperature dependencies and non-linearities of the sensor are mathematically compensated. With the READ30 software and the KELLER cable K-107, the calculated pressure can be displayed on a Palmtop, Laptop or PC. The READ30 software also allows the recording of pressure signals and the graphic display on the PC. Up to 128 transmitters can be hooked together to a Bus-system.
Transmitter with Analog Output
The micro-processor integrates a D/A converter of 16 bit for analog signal outputs of 4…20 mA or 0…10 V. The output rate is 100 Hz (adjustable). The digital output is available on all transmitters with analog output.
Each Series 30 transmitter also integrates a digital interface (RS485 halfduplex) which you can make use of: Connect the transmitter to a PC or Laptop via the converter K106 (RS232-RS485). All new series 30 sensors can be programmed with the CCS30 software as well as the two previous Keller software programmes (READ 30 and PROG30). The CCS30 software, along with other drivers and software packages are included with the K114 download cable & software packs.
1...30 bar (abs./rel.)
||0,1 % FS
|Linearity (best straight line)
|Long Term Stability, Range ≤ 1 bar
Long Term Stability, Range > 1 bar
|Storage-/Operating Temperature Range